Linksys SPA901

It's a one-line IP telephone, without a display and with an Ethernet port, that is why you must have a switch or router connection. It includes a power adaptor to power the device.

Step 1: Wiring


To power the terminal you must connect it to a wall socket using the adaptor included. The adaptor is mounted as described here. You must connect the small plug in the power adaptor to the corresponding telephone input, as shown in the figure.

Setup - SPA901 - PowerZoom


You must connect a cable from the router or switch to the Ethernet connector marked WAN.

Setup - SPA901 - NetworkZoom

Paso 2: Setup

Once the telephone has been connected to the network, if you have DHCP in your network (it is the most usual case) the telephone will take an address in your local network automatically. Otherwise, the telephone should be previously included in the network manually. To this end, contact your network administrator and consult the terminal's manual.

Once the telephone is in the network, it can be set up using its MAC ID (it is printed on the sticker on the back of the telephone). The telephones and adaptors must be set up using our Configurer following the steps indicated here.

Setup - SPA901 - SetupZoom

If you cannot use Configurer you must complete the telephone's installation following the steps in its manual and using the SIP setup that you may obtain in the control panel's extensions.

Once both steps are completed, you can start using your terminal as described in the Dialing section.

Monema for Business

Telephony, virtual PBX and fax

Virtual PBX, minute plans for landline and cellular phones, easy-to-use control panel, immediate setup and a 30-day free trial.

Centralita Virtual

See more

Contact us

In Monema we are delighted to serve you. If you need additional information on our services you can reach us by chat, or our online form:

Contact us